It is currently Thu Nov 27, 2014 12:40 am

All times are UTC - 6 hours





Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Interface Conversion Switch
PostPosted: Thu Jun 03, 2010 8:05 pm 
Offline
 Profile

Joined: Mon May 31, 2010 12:32 pm
Posts: 3
I been reading The Deck legend user manual (the PDF version) According to UPS tracker I not getting my keyboard till June 4, tomorrow.

I was reading the Interface conversion section about "interface can be changed from PS/2 to USB and vice-versa".
It reads "clip-out and discard the 10K Ohm resistor at 'W3' " for PS/2 to USB conversion. And to solder a 10K Ohm resistor to change it back.

I was thinking of placing a switch that allows me to connect and disconnect the resistor instead of soldering and unsodering it.
I am thinking of keeping this switch internal for safety sakes, I don't want to leave out the resistor in PS/2 mode or leave it in on USB mode.
That way, when I have to switch the cord around; I just have to open up the Keyboard, flip the cord around and flip a single switch.


What do you guys think?


Top
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours



Who is online

Users browsing this forum: Google [Bot] and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group  
Design By Poker Bandits