This one is ICE with a clear housing with white LEDs around the perimeter.





Here is one I had fun with it started off as Ice then I added a clear housing that I painted blue in the inside and put silver flames on the out side.















This one is fire with a clear housing

hi Max. how did you do your flames? I was thinking about making a stencil, then airbrush with the proper paint. thanks for your advice.
walko

stencil, then airbrush would work good I would do that if you had a airbrush gun, But what I did was covered the housing with masking tap (it’s a paper tape any kind) then just drew out the flames that I wanted and took a x-acto and cut on the lines peeled what I didn’t want off and sprayed the paint. Hope this helps and good luck bud.

Very nice mods!